Stackable Control Valves

The SVW1BA1 is a 3 position lever valve that will spring to back to center. Examples of use are: Squaring Arm control, Log Taper, and Log Lift.

The SVW1BA9 valves are used when a joystick is needed. The joystick control takes the place of 2 lever valves. One joystick can raise and lower the log clamps and slide them back and forth where ths would normally take two lever valves to do the same action. Examples of use are: Log Clamps and Log Turner.

SVW1BA1 Valve

Only

6.00lbs

Comes with lever

This is a lever valve that will need (1) Inlet valve and (1) outlet valve in order to stack them together to make a complete circut.

SVW1BA9 valve

Only

6.00lbs

This is the valve that is used to make a joystick control.

2 of these are required to make the joystick section.

Items needed to make this valve functional:

(2) SVW1BA9 stacked together
(1) Joystick
(1) Boot for Joystick
(1) Inlet Valve
(1) Outlet Valve

Joystick kit

Only

1.00lbs

This is needed when purchasing the SVW1BA9 valve.

The joystick boot is also needed when ordering this part.

Joystick Boot

Only

Larger picture

0.25lbs

This is needed when order the joystick.

Inlet Valve no relief

Only

Larger picture

4.00lbs

One of these is needed along with one Outlet Valve when building a work section. The inlet goes on one end of the stack and the outlet goes on the other end, making a complete work section.

Inlet Valve with relief

Only

4.00lbs

One of these is needed along with one Outlet Valve when building a work section. The inlet goes on one end of the stack and the outlet goes on the other end, making a complete work section.

Outlet Valve

Only

Larger picture

4.00lbs

One of these is needed along with an Inlet valve to complete a work section.